Photo #1

• To install the flat base to make a hole of 12 to 15 mm. (Photo #2)

Photo #2

• To install the air base is sufficient with a hole 3 to 5 mm.
• The bases are cables pass beneath the dashboard layout and then connect them in parallel (Photo #3)

Photo #3

• When fitted with LED lighting: connect the red or orange wires to the positive [+] and black to negative [-]
• The parallel connected and a processor 12 to 16 volt (Photo #4)

Photo #4

• Each light post has two connectors on the top, two cables or a jack.
  The connector is part marked in red or orange to red wire and the other belongs to the black wire connector.
  So we will know the polarity: red or orange = positive [+] and black = negative [-] (Photo #5)

Photo #5

• WARNING: Do not adjust the LED lamp models carrying as these models are not equipped with resistance and could damage the LED.